Maintenance Instructions 1
Receiver with barrel, cocking lever housing and magazine release lever Cleaning the barrel, cocking lever housing and magazine release lever and checking all assemblies and subassemblies for proper seat gt Clean and oil receiver, barrel extension and barrel. Note When cleaning the barrel, the flash hider must be screwed onto the barrel. Cleaning rod 1013-101.49 W24 Chamber cleaning kit 1013 W3 1 Gauges
Maintenance Instructions Lzi
Stripping, cleaning and checking the bolt assembly. gt Clean the bolt components. gt Check bolt components 23-26 for damages, dents and wear, replace, if necessary see sheet 3.4 .
Maintenance Instructions Pdv
Checking the firing pin protrusion Checking the shape of firing pin gt To measure the firing pin protrusion, both firing pin 24 and locking piece 23 must be introduced entirely into the bolt head 26 so that the firing pin protrudes at the bolt face. gt The GO side of the gauge is place on the firing pin. The front measuring flat side must rest on the bolt face. gt The firing pin protrusion is correct if the GO size is 1.14 1.60 mm. gt Check the shape of the firing pin as shown in the figure...
Maintenance Instructions Wbn
Cleaning and checking the grip assembly gt Remove trigger housing 40 from pistol grip. gt Take off grip 36 , by removing screw 37 and washer 38 . gt Clean trigger housing and pistol grip. gt Check components for damages, dents and wear. gt Replace components, if necessary. gt After reassembly, check trigger mechanism and safety for smooth operation. Cleaning and checking back plate and butt stock gt Clean back plate with butt stock. gt Check for damages, dents and wear. gt Check recoil spring...
Maintenance Instructions Bjh
Receiver with barrel, cocking lever housing and magazine release lever Removing dents in the receiver and cocking lever housing gt Remover dents in the receiver and cocking lever housing with straightening mandrels and plastic hammer. gt Clamp barrel with receiver into vice and check guide in the receiver for smooth operation of bolt assembly by means of GO and symmetry gauge. Straightening mandrel for receiver 1013-100 W6 Straightening mandrel for cocking lever housing 1013-100 W5 Gauges GO...
Maintenance Instructions
Receiver with barrel, cocking lever housing and magazine release lever Replacing the flash hider and checking the rifle grenade for its proper seat on the rifle Replacing the cap gt Loosen flash hider 2 by means of the universal spanner and remove. Screw new flash hider onto the barrel and tighten securely. gt Slide control gauge over flash hider and spring ring up to limit stop at the front sight holder. gt Check flash hider for symmetrical seat as well as spring ring for secure seat on the...
Division
Section 1. Maintenance Checking the rifle before shooting - Safety engaged, rifle Sighting-in of the Adjusting the rear Checking the Head Replacing the flash hider and checking the rifle grenade for its proper seat on the rifle Replacing the Cleaning the barrel, cocking lever housing and magazine release lever and checking all assemblies and subassemblies for proper Removing dents in receiver and cocking lever Viewing the bore for powder residues and checking the bore Checking the rear and...