BAYONET MS ASSEMBLY fig
a« Insert scabbard catch spring in well in blade handle just to rear of guard.
b» Insert small end of scabbard catch into well to bear on spring, with hook of catch projecting forward through slot in guard.
e. Press scabbard catch against spring and insert small end of bayonet catch, from left, through hole in scabbard catch. Push bayo-
\ ESCUTCHEON i A15264-1
ORDNANCE MAINTENANCE - U.S. RIFLES, CAL. .30, Ml903, M1903A1, Ml903A3 AND M1903A4
SCREW - A1527 31 " CRIP - C64037
CATCH - B147059 \
• ESCUTCHEON - A152645 SPRING - B147063'
BLADE ASSEMBLY
D35351
CATCH - B147058
CRIP C64036
RA PD 84294
Figure 59 — Bayonet M1905 — Exploded View of Handle net catch forward and in toward blade handle so that hook projects into bayonet stud slot in rear end of blade handle, and body of catch seats in cut in bridge of blade handle.
d. Reposition escutcheons in grips, if removed, and seat right grip on blade handle and insert grip screw through grip, blade handle, and bayonet catch. Then seat left grip, thread screw into it, and draw down tight c. Test both catches by pressing in scabbard catch and releasing. It should return by spring pressure and both catches should then be in locked position.
21. BAYONET Ml, DISASSEMBLY (fig. 60).
a. This bayonet is basically identical with the Bayonet M1905 except for length of blade and minor points in design. The grips are of composition instead of wood. The escutcheons are sealed in at manufacture and should not be removed. Disassemble as prescribed for the Bayonet M1905 in paragraph 19.
(CUARD>
SCREW - A152131 CRIP-Cl 13681
CATCH - B147059
SPRING - BI47C63
CATCH - B14705S
CRIP - CM3680
RA PO 79914
Figure 60 — Bayonet Ml — Exploded View of Handle
(CUARD>
CATCH - B14705S
CRIP - CM3680
SCREW - A152131 CRIP-Cl 13681
CATCH - B147059
SPRING - BI47C63
RA PO 79914
Figure 60 — Bayonet Ml — Exploded View of Handle
a. This bayonet is basically identical with the Bayonet M1905 as stated in paragraph 21. Assemble as prescribed for the Bayonet M1905 in paragraph 20.
23. TELESCOPIC SIGHT (RIFLE M1903A4), DISASSEMBLY
a. The telescopic sight used with the Rifle M1903A4 should not be disassembled. Removal of the mount rings is explained in paragraph 58. Damaged sights should be sent to a base shop (or the factory) for repair or disposal.
24. TELESCOPIC SIGHT (RIFLE M1903A4), ASSEMBLY (figs. 8 and 58).
a. There being no disassembly permitted of the telescopic sight used with the Rifle M1903A4 with the exception of the removal of the mount rings, no assembly is required except the replacement and adjustment of the mount rings when necessary. This procedure is explained in paragraph 58.
Section 111
Post a comment